SMC EliteConnect Wireless Bridge Uživatelská příručka stáhnout pdf (Strana 153)

Entering Commands

7-5

Exec Commands

When you open a new console session on an access point, the system enters Exec

command mode. Only a limited number of the commands are available in this mode.

You can access all other commands only from the configuration mode. To access

Exec mode, open a new console session with the user name “admin.” The

command prompt displays as “SMC AP#” for Exec mode.

Configuration Commands

Configuration commands are used to modify access point settings. These

commands modify the running configuration and are saved in memory.

The configuration commands are organized into four different modes:

• Global Configuration (GC) - These commands modify the system level

configuration, and include commands such as username and password.

• Interface-Ethernet Configuration (IC-E) - These commands modify the Ethernet

port configuration, and include command such as dns and ip.

• Interface-Wireless Configuration (IC-W) - These commands modify the wireless

port configuration of global parameters for the radio, and include commands such

as channel and transmit-power.

• Interface-Wireless Virtual Access Point Configuration (IC-W-VAP) - These

commands modify the wireless port configuration for each VAP, and include

commands such as ssid and authentication.

To enter the Global Configuration mode, enter the command configure in Exec

mode. The system prompt will change to “SMC AP(config)#” which gives you access

privilege to all Global Configuration commands.

To enter Interface mode, you must enter the “interface ethernet,” or “interface

wireless a,” or “interface wireless g” command while in Global Configuration

mode. The system prompt will change to “SMC AP(if-ethernet)#,” or SMC

AP(if-wireless)” indicating that you have access privileges to the associated

commands. You can use the end command to return to the Exec mode.

Username: admin

Password: [system login password]

SMC AP#

SMC AP#configure

SMC AP(config)#

SMC AP(config)#interface ethernet

SMC AP(if-ethernet)#

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 317 318

Žádné komentáře

SMC EliteConnect Wireless Bridge Uživatelská příručka Strana 153